|
Related Links: Wall Fitting Kit , Aerial Fitting Kits , Bracketry , Masts , TV Aerials Firstly mount the bracket in a suitable position normally just below the gutter on the brickwork. Ensure the position you have chosen will allow the aerial to point toward the transmitter un-obstructed. Drill four 10mm holes using the bracket as a pattern, try to drill into separate bricks-NOT mortar. Now mount the bracket. Loosely fit the two pole U bolts. Now, back on the ground, you can assemble and fit the aerial on to the pole. Fix your coax cable on to the dipole (the blue/black box on the aerial) make sure you use the rubber weatherproof grommet. Now back up the ladder with the aerial attached to the pole and one end of the coax fitted into the dipole. Slide the pole into the U bolts on the bracket and hand tighten the nuts. Before fully tightening point the aerial in the right direction for your transmitter Do not over-tighten, if it’s aluminium, just a ‘hard pinch’. Now drill your hole from inside the house where the cable will go, tack your cable down the wall and feed through hole. Fit connector, job done! For long poles use T&K Wall brackets. Please note this is intended as a 'guide' only and aerial shack takes no responsibility should you have any difficulties or mishaps.
|
